Removing the ball holder
1. Remove the cotter pin from the locking bolt and slide the locking bolt out of the ball holder/hitch assembly.
2. Pull the ball holder out of the hitch assembly.
NOTE
A cover for the hitch assembly is also
included in the kit.
See also:
Tilt position
Tilt position, raised at the rear edge
1 Open (raise the rear edge of the front glass
section) by pressing the rear edge of the
control upward.
2 Close by pulling the rear edge of the control ...
Messages
When a warning, information or indicator symbol comes on, a corresponding message
appears on the information display. An error message is stored in a memory list
until the fault is rectified.
P ...
Driver Alert Control (DAC)– introduction
This function is intended to alert the driver if his/her driving becomes erratic,
such as if the driver is distracted or fatigued.
NOTE
The camera has certain limitations, see page 160.
A ...