See also:

Replacing the turn signal bulb
1. Turn the lamp holder approximately 1/4 turn counterclockwise and pull it out of the headlight housing. 2. Press in the bulb slightly and pull it out of the holder. 3. Align the guide lugs on ...

Installing the ball holder
1. If necessary, remove the cotter pin from the locking bolt and slide the locking bolt out of the hitch assembly. 2. Slide the ball holder into the hitch assembly. 3. Align the hole in the ball ...

Operation
Controls and display 1 Resume previous settings, increase speed (each additional press increases speed by 1 mph (approximately 2 km/h). 2 Standby mode on/off 3 Set time interval 4 Put in activ ...