License plate lights
1. Switch off the ignition.
2. Loosen the screws with a Torx screwdriver.
3. Turn the bulb holder counterclockwise and
pull it out.
4. Pull out the defective bulb and insert a new
one.
5. Reinsert the bulb holder into the housing
and turn it clockwise.
6. Reinstall the housing and screw it into
place.
NOTE
Other bulbs may be difficult for you to
replace yourself. Let a trained and qualified
Volvo service technician replace these
bulbs if necessary.
See also:
Heated oxygen sensors
The heated oxygen sensors monitor the oxygen content of the exhaust gases. Readings
are fed into a control module that continuously monitors engine functions and controls
fuel injection. The ratio ...
How HD broadcasting works
HD Radio works similarly to conventional radio and broadcasts of this type are
available in many areas of the United States. However, there are a few key differences:
Instead of transmitting one ...
Re-installing the wheel
1. Clean the contact surfaces on the wheel and hub.
2. Lift the wheel and place it on the hub.
Tighten the lug nuts
3. Install the wheel nuts and tighten handtight. Using the lug wrench, tighten ...