Power moonroof
To operate the moonroof, turn the ignition key to position I or II, or start the engine. The moonroof can be operated in two ways:
A Tilt position
B Sliding moonroof
Tilt position
Open: With the moonroof closed, push up the rear edge of the switch (position 5 in the illustration in the center column).
Close: Pull down and hold the rear edge of the switch (position 6 in the illustration in the center column) until the moonroof has closed completely.
Sliding moonroof
Manual open: Pull the switch rearward to position 3 and hold it until the moonroof has opened to the position of your choice.
Auto open: Pull the switch as far back as possible (position 4) and release it to automatically slide open the moonroof to the "comfort"1 position. Pull the switch rearward again to open the moonroof completely.
Manual close: Push the switch to position 2 and hold it until the moonroof has closed completely or to the position of your choice.
Auto close: Push the switch forward as far as possible (position 1) and release it to automatically close the moonroof.
CAUTION
• Remove ice and snow before opening
the moonroof.
• Do not operate the moonroof if it is frozen
closed.
• Never place heavy objects on the
moonroof.
WARNING
• Never open/close the moonroof if it is
obstructed in any way when in operation.
• Never allow a child to operate the
moonroof.
• Never extend any object or body part
through the open moonroof, even if the
vehicle's ignition is completely
switched off.
• Never leave a child alone in a vehicle.
If the moonroof is obstructed during auto-close operation, it will automatically reverse direction and return to its starting position. If the moonroof is repeatedly obstructed during auto-close operation, an overload circuit breaker will temporarily halt moonroof function. The moonroof will return to normal function after a brief cooldown period.
Sun visor
The optional moonroof also features a sliding sun visor. The visor slides open automatically when the moonroof is opened. The visor must be closed manually.
WARNING
The moonroof must never be obstructed in
any way when in operation.
See also:
Ambient lighting conditions
The camera automatically monitors the ambient
lighting conditions behind the vehicle and
constantly adjusts sensitivity to light. This may
cause the brightness and quality of the image
on the ...
Introduction
The HomeLink1 Wireless Control System provides
a convenient way to replace up to three
hand-held radio-frequency (RF) transmitters
used to activate devices such as gate operators,
garage door op ...
On and off
To switch Collision Warning on or off, press MY CAR on the center console control
panel and go to Settings Car settings Driver support systems Collision Warning.
If Collision Warning is on, the sy ...