Taking out the spare wheel
1. Release the bag's retaining straps.
2. Lift the bag out of the vehicle and remove the spare wheel from the bag.
3. Fold up the floor hatch in the trunk.
4. Remove the jack* and tools* from the foam block and change the wheels (see the instructions in the following section "Changing a wheel").
5. After changing wheels, return the jack and tools to the foam block and close the floor hatch.
6. If possible, place the wheel with the punctured tire in the bag.
7. If there is a wheel in the bag, strap the bag securely in place in the trunk.
See also:
Air distribution
1 - Manual air distribution—defroster 2 - Manual air distribution—dashboard
air vents 3 - Manual air distribution—floor
The figure consists of three buttons. When a button is pressed, the corre ...
Ignition mode I
NOTE
To access ignition modes I or II without starting
the engine, the brake pedal must not be
depressed.
- With the remote key fully pressed into the
ignition slot, press START/STOP
ENGINE ...
Fault tracing and actions
If the message Windscreen Sensors
blocked is displayed, this means that the camera
is obscured and cannot detect pedestrians,
vehicles or road marker lines in front of the
vehicle.
This, in t ...