Removing a paired device

1. In Bluetooth mode, press OK/MENU.
2. Turn TUNE to Remove Bluetooth device and press OK/MENU.
3. Select the device to be removed by turning TUNE and confirm by pressing OK/ MENU.
> A question asking if you would like to remove the device will be displayed.
4. Press OK/MENU to confirm or EXIT to cancel.
See also:
Selecting a magnetic zone
Magnetic zones.
The earth is divided into 15 magnetic zones.
The correct zone must be selected for the compass
to work correctly.
1. Put the ignition in mode II.
2. Using a pen or similar obje ...
Taking out the spare wheel
1. Open the floor hatch.
2. Undo the retaining bolt.
3. Lift out the foam block.
4. Lift out the spare wheel.
The other two blocks can remain in the spare
wheel well.
After use
The foam block ...
Introduction
The HomeLink1 Wireless Control System provides a convenient way to replace up
to three hand-held radio-frequency (RF) transmitters used to activate devices such
as gate operators, garage door op ...
