Park position (P)

Select the P position when starting or parking.
Shiftlock
When P has been selected, the transmission is mechanically blocked in this position. The brake pedal must be depressed and the ignition must be in at least mode II (see page 86) before the gear lever can be moved from the P position.
Always apply the parking brake when the vehicle is parked. Press the control to apply the brake, see page 124.

CAUTION
The vehicle must be stationary when position P is selected.
See also:
Fault tracing and actions
If the message Radar blocked See manual is
displayed, this means that the radar signals
from the sensor have been obstructed and that
a vehicle ahead cannot be detected.
This, in turn, means th ...
Tilt position
Tilt position, raised at the rear edge
1 Open (raise the rear edge of the front glass
section) by pressing the rear edge of the
control upward.
2 Close by pulling the rear edge of the control ...
Parking brake
1 Parking brake pedal
2 Handle for releasing the parking brake
The parking brake pedal is located under the
dashboard, to the left of the brake pedal.
NOTE
The indicator light will light up eve ...
