Erasing HomeLink Buttons

To erase programming from the three Home- Link buttons (individual buttons cannot be erased but can be “reprogrammed” as outlined below), follow the step noted:
1. Press and hold the two outer HomeLink buttons until the indicator light begins to flash-after 10 seconds.
2. Release both buttons. Do not hold for longer that 20 seconds.
HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with “Programming” - step 1.
See also:
Trip computer
A READ (press to acknowledge/confirm/erase a message)
B Thumb wheel (used to scroll among the trip
computer menus)
C RESET
The trip computer stores information gathered
from several systems in ...
ABS with EBD (Electronic Brake ForceDistribution)
EBD is an integrated part of the ABS system.
EBD regulates the hydraulic pressure to the
rear brakes to help provide optimal braking
capacity. The brake pedal will pulsate during
braking, which ...
Replacing bulbs in the taillight cluster
1. Switch off all lights and turn ignition key to
position 0.
2. Fold down the lower section of the tailgate,
and fold up the rear section of the cargo
area floor.
3. If the vehicle is equipped ...
