Active Bending Lights (ABL)*
Headlight pattern with the Active Bending Light function deactivated (left) and activated (right)
When this function is activated, the headlight beams adjust laterally to help light up a curve according to movements of the steering wheel (see the right-pointing beam in the illustration).
ABL is activated automatically1 when the engine is started.
The function can be deactivated/reactivated in the MY CAR menu system under My S60 Active Bending Lights or under Settings Car settings Light settings Active Bending Lights.
See page 133 for a description of the menu system.
NOTE
This function is only active in twilight or dark conditions, and only when the vehicle is in motion.
If a fault should occur in the system, the symbol will illuminate and a message will be displayed as shown in the table.
See also:
Operation
Controls and display
1 Resume previous settings, increase speed (each additional press increases
speed by 1 mph (approximately 2 km/h).
2 Standby mode on/off
3 Set time interval
4 Put in activ ...
Ignition switch and steering wheel lock
A The gear selector must be in the P (Park) position (automatic
transmission).
B Please be aware that leaving the key in this position will
increase battery drain. ...
Heated oxygen sensors
The heated oxygen sensors monitor the oxygen content of the exhaust gases. Readings
are fed into a control module that continuously monitors engine functions and controls
fuel injection. The ratio ...