Scan
This function plays the first ten seconds of each track/audio file. To start scanning:
1. Press OK/MENU.
2. Turn TUNE to Scan.
> The first ten seconds of each track/ audio file will be played.
3. Stop scanning by pressing EXIT. The current track/audio file will continue playing.
See also:
Jump starting
Connecting the jumper cables
Follow these instructions to jump start your vehicle's dead battery or to jump
start another vehicle's dead battery using your vehicle. If the 12-volt auxilia ...
Cleaning the sensors
Location of the front sensors
Location of the rear sensors
The sensors must be cleaned regularly to ensure that they work properly. Clean
them with water and a suitable car washing detergent. ...
Introduction
The HomeLink1 Wireless Control System provides
a convenient way to replace up to three
hand-held radio-frequency (RF) transmitters
used to activate devices such as gate operators,
garage door op ...