Using the infotainment system

If the infotainment system is on when the ignition is switched off, it will come on automatically the next time the ignition is put in mode I or higher and continue using the same source (FM1, etc.) that was in use when the ignition was switched off (the driver's door must also be closed on vehicles with the optional keyless drive).
The infotainment system can be operated without a key in the ignition slot for 15 minutes at a time by pressing the On/Off button.
While the engine is being started, the infotainment system will be temporarily interrupted and will resume when the engine has started.
NOTE
To help avoid excessive battery drain,
remove the remote key from the ignition slot
if the infotainment system is used while the
engine is switched off.
See also:
Brake lights and taillights
The brake lights and taillights are replaced from
inside the cargo area.
NOTE
Before starting to replace a bulb, see
page 322.
1. Open the panel.
2. Remove the bulb holder by turning it coun ...
Introduction
Collision Warning with Full Auto-brake and Pedestrian Detection is designed to
assist the driver if there is a risk of a collision with a pedestrian, a vehicle
ahead that is at a standstill or one ...
High/low beam headlights
Continuous high beams
1. Turn the ignition key to position II.
2. With the light switch in position ,
(see
page 67) pull the turn signal lever toward
the steering wheel to toggle between high
a ...
